×

:

Not a valid Time
This is a required field.

Mayhems Blitz 100ml Kit Pro Cleaning System

Out of stock
SKU
Mayhems Blitz 100ml Kit Pro Cleaning System

Contents
· 100ml Mayhems Blitz Part 1, Just add 750ml of water (will dilute to 1 Ltrs of fluid)
· 100ml Mayhems Blitz Part 2, 100ml (will dilute to 4 Ltrs of fluid)
· Rubber Gloves 4 sets
· Safety Goggles 
· Instructions
· Warning Sheet

Part 1 Mayhems Blitz Cleaning

For internal use on Copper / Brass radiators only.
Do not use on plated products.
Do not spill on paint work and if you do so, rinse off immediately.

· Maximum effectiveness
· Rapid neutralisation of surface rust, contamination and oxidation
· Rigorous removal of mineral scale deposits
· Excellent suspension of particulates
· Low foaming
· Hard water tolerant
· Can be disposed of down grey-water (waste / outside) drain
· With "Care" this is easy to handle and straight forward to use
· May Improve heat transfer rate

Usage of Part 1 of the Mayhems Blitz Cleaning System

1. Put on the Gloves provided in the kit.
2. Mix Part one with deionised water / distilled water (either will do) to a ratio of 250ml of part 1 to 750ml of water.
3. Add to the radiator and clean up any spills immediately.
4. Vent the system of any trapped air and cap the radiator.
5. Leave in Radiator between 6 to 12 hours.
6. After empty down the waste drain. Refill with deionised water / distilled water (either will do) and rise out.
7. Repeat step 6 two times.
8. Refit to loop and move to Part 2 of the cleaning system.


Part 2 Mayhems Blitz Cleaning System

· pH neutral (Ph7 -0.5 / +0.5)
· Effective neutralisation of contaminants.
· Good removal of slime, silt & detritus
· Excellent suspension of particulates
· Hard water tolerant
· Can be disposed of down grey-water (waste / outside) drain
· May Improve heat transfer rate

Usage of Part 2 Mayhems Blitz Cleaning System

1. Drain existing system contents.
2. Mix Part two with deionised water / distilled water (either will do) to a ratio of 25ml of Mayhems Blitz part 2 to 975ml of water.
3. Mayhems Blitz Part 2 will create a lot of foam. Please add to system slowly, do not over fill.
4. Vent the system of any trapped air. Do this by tilting the pc to release any tapped air from the radiator.
5. Check for leaks. Using just the pump, recirculate the fluids for 24 hours continuously. Regularly check any installed filters and clean as necessary.
6. Refill with deionised water / distilled water (either will do).
7. Run for 30 minutes
8. Empty out and refill with deionised water / distilled water (either will do)
9. Run for 30 minutes
10. Empty out and fill with your favourite coolant.